Plant / Clutches

Advertising







Connectors For Construction Machinery

Switching gears for construction equipment is necessary as in this way achieves a better ratio that is needed to control them. Select gears with the clutch pedal depressed.

During construction, machinery clutch mechanism is used to increase or decrease the speed of rotation to reverse the direction of rotation or move to a different rotation axis and rotation to keep the two axes are synchronized. Usually by changing gears with the clutch rotation is faster because it goes to a higher speed.

When switching from higher to a lower gear, rotation becomes less. During construction machines, except for the transition from lower to a higher gear and reverse, clutch serves to switch into reverse. Surely the coupling device is required for each vehicle.

When the machine must stop without damaging the engine and then the wheels must be separated from it in some way. The driver should use the clutch. This is a smooth gear and the speed is then reduced gradually. When using the clutch increases the friction between it and the flywheel. Flywheel connects to the engine construction plant, and transmission is associated with the clutch disc.

The springs allow pressure on the clutch disc when the brake pedal is depressed and thus it is pressed against the flywheel. Lock entrance drive shaft of the engine and begin to rotate at the same speed. The size of the coupling strength depends on the friction that occurs between its disc and flywheel. In the clutch, the friction force can be the same as for the brakes, but the goal to be achieved in management is different.

If the machine is equipped with a new clutch, it will work much better because the switch will become easier. Modern connectors are more reliable and last longer, withstand greater loads and are more secure.